crestron control processor 3 how to send samsung rs232 command

The CIPPORT is 41794, this port is used for Ethernet control such as in xpanel and roomview. Note: Console commands, and in the window will return the current settings of the processor. The window of the view will return the current CIPPORT and CTPPORT. Note: Console command, in the window will return all of your IP information including the IP address of the processor. The window of the view will return the current Control Processor settings Select then, the processor will then reboot Note: If assigning a fixed IP Address, this must be outside of the DHCP range of the Router being used.Ģ) Assign the Default Router to the Control Processor, this should be the local IP Address of the installed Router being used. Select from the pull down menu, ġ) Assign an IP Address and IP Mask that is within the range of the installed routerĮx. You need to assign 3 IP fields, IP Address, IP Mask, Default Router. How to setup the Control Processors IP address:Ĭonnect to the Control Processor using Toolbox, view. Note: For a Linksys router it is under the status tab.Īn easy way to find your public IP Address is to hook a computer up through the router and go to here. Note: Additional information can be found in the eControl Reference Guide.ģ) Your CIPPORT and CTPPORT on the Control Processorĥ) Viewport or Toolbox, either can be used for all of the described tasks.ĭifferent routers show this in different places. Connecting to your processor remotely, what to Setup and Configure:

Crestron control processor 3 how to send samsung rs232 command